AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Automatic pool covers austin4/11/2024 ![]() One large reel on one side stores the actual cover material the other smaller reel holds the cables. A motor turns the reels to extend or retract the vinyl cover fabric. Parts: IMG: APC Inc How an Automatic Pool Cover WorksĪn automatic pool cover uses a pulley system with two reels connected by cables or ropes running through tracks along the pool edges. This removes any standing water on top and is critical for safety.Ĭables – Steel cable, nylon, or poly ropes that attach to the lead edge and spool up on reels in the housing to retract the cover when opening. They roll in the tracks for smooth movement.Ĭover Pump – This safety pump is usually placed on the closed cover and hooked to a GFCI (ground-fault circuit interrupter) outlet. Gliders/Wheels – Wheels or low-friction gliders mounted under the lead edge bar. ![]() ![]() The lead edge rolls along these tracks, keeping the cover aligned perfectly as it opens and closes. Tracks – Guide rails mounted into the pool coping or deck along the sides. It pulls the cover out of the housing when opening and rolls the fabric onto itself when closing the cover. Lead Edge – This front metal or plastic bar attaches to the pool cover fabric. The cover fabric neatly rolls up into the housing when opening the pool. Housing – This deck or recessed box stores the electric motor and mechanical drive components. Pressing buttons for Open or Close initiates the cover retraction or extension. It is usually a keypad, touchpad, or switch mounted on a nearby wall or post. Here are the main components of an automatic pool cover system:Ĭontroller – This control panel or switch activates the opening and closing of the cover. It sits on the pool’s surface and completely seals off the water when closed. It is a powered cover that you can extend or retract at the push of a button or flick of a switch. This is normal and not an indication of trouble.Should I Leave the Cover Pump on the Cover at All Times? Automatic Pool Covers: Basics What is an Automatic Pool Cover? Sometimes the ropes will make this popping noise when they pass through the different pulleys and onto the rope reel. Q: What is the popping noise I hear when I open and close the cover? Place the pump back on when the ice begins melting. We recommend using the 40FT Power Cord Pump from APC. If it is too cold to melt the ice and snow on the cover, pull the pump off and place it in a warm area. ![]() The only exception is during severe winter conditions. The cover pump should be left on the cover at all times. Q: Should I leave the cover pump on the cover at all times? Please contact your service representative. This should be accomplished by a trained technician. Fill the pool to a level where the water supports the system, or call for service. Q: If I drain my pool or if the water leaks out, should I close my cover?Ĭlosing the cover when the water level is any more than six (6) inches below the skimmer could cause damage to the system. Please contact your service representative for instructions. Q: Can the cover be opened/closed manually? Our vinyl is designed to have fewer wrinkles than the laminated vinyl that is used by other manufacturers. Initially, the fabric could appear wrinkled or oversized, but these wrinkles are normal and may smooth out. No, the fabric is manufactured to include extra material for winterization. Yes, but we recommend only in an emergency. If you have additional questions, please don't hesitate to contact us for more information. Below you'll find some frequently asked questions we receive from automatic pool cover owners and partners. ![]()
0 Comments
Read More
Leave a Reply. |